Max Systems LabelMax XS Servisní příručka stáhnout pdf (Strana 30)

Section 3: Configuration and Operation

Page 3-8 SATO D508/D512 Operator Manual

3.5 OFFSETS

There are two offset settings stored in the printer; one for the Cut mode and one for the Tear-Off

mode.

These two offsets can be set independently and will remain in the printer until a new command is

received changing the setting or until power is turned off.

The default settings can be determined by printing a User Test Label.

The following should be used as starting points for establishing the three Offset values:

Mode Length of Offset (mm) Length of Offset (in) Print head resolution

CUTTER 17.9 0.70 143/215

TEAR-OFF 29.2 1.15 234/350

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 59 60

Žádné komentáře

Max Systems LabelMax XS Servisní příručka Strana 30